|
| |
components:
Bulbs Unlimited Packs contain
all components which are required to transform (burnt through)
standard light bulbs (E27) into your custom built light objects.
In this chapter we show how to use “Inkubator”,
snap buttons and glue to generate low cost light sources.
Light bulbs used in light object could be easily re-used
for further constructions, by simple deassembling.
|
|
|
|
|
|
|
|
| |
Just...
....open the „* Inkubator“ and
drop a bulb inside.
*
The "Inkubator" is
the core part of the Bulbs Unlimited system and should capture
the bulbs for defining glue points for connecting snap buttons.
Therefore the surface of the Inkubator contains holes. Every
hole is consecutively numbered and leads a waterproofed pen
to the included bulb. Construction
manuals show which number combination you should use
for building the different shaped light objects.
|
|
|
|
|
|
|
| |
then...
add
marks for snap buttons on bulb`s surface by pointing a pen through
the holes of the Inkubator. Everry hole is consecutively numbered.
Using different number combinations enables the building of light
objects with different shapes and sizes.
Afterwords remove
the marked
bulb...
|
|
|
|
|
|
|
| |
then...
add glue on marks and let
it dry for a while.
|
|
|
|
|
|
|
| |
stick
Snap Buttons...
after a few minutes stick
snap buttons on marks and let the glue fully cure..
|
|
|
|
|
|
 |
| |
after...
glue is completely hardened,
just plug the light bulbs together like Lego® bricks.
If you get bored by a light object, just deassemble it and
build a new one. .
>> more
light objects
|
|
|
|
|
|
 |
|
and
finaly...
plug bulbs
together and fix them with nylon strip on lamp holder ring.
There it goes your new light object. Find different example light objects here... |
|
|
|
|
